International Science Community Association Research Journal of Engineering Sciences 2278 - 9472 5 4 2016 April 26 Process Linked with Plate Mill and Development of Data Acquisition System to Display Process Parameter 30 35 EN Lalit Kumar Sahu 1 Department of Electrical Engineering, CSVTU, Bhilai, India Dushyant Singh 2 Department of Electrical Engineering, CSVTU, Bhilai, India Bhupendra kumar 1 Department of Electronics and Telecommunication Engineering, Bhilai Institute of Technology Durg, India Ekta Tamrakar 2 Department of Electronics and Telecommunication Engineering, Bhilai Institute of Technology Durg, India Jayant Kumar Rai 1 ET and T Department, FET, SSGI, SSTC, Bhilai, India Chandrashekhar Kamargaonkar 2 ET and T Department, FET, SSGI, SSTC, Bhilai, India M.S. Mandloi 1 Department of Electronics and Communication Engineering, Rewa Engineering College Rewa, 486002, M.P., India Narendra Rathia 1 E and TC Department, BIT, Durg, India Dewangan Chitesh Kumar 2 E and TC Department, BIT, Durg, India > Research Article 2016 2 24 2016 April 26 In plate mill process parameters are required to keep under observation for proper operation of industrial plant and all the parameters like temperature, gas and pressure should be within the limit and it should not go beyond the limit which would become hazardous for those who are working in the plant. So for this we need to develop a data acquisition system to properly observe all the process system of one plant. It will be very useful in compilation of data and training purpose of staffs. The system going to be designed consists of potentiometer, analog to digital converter, microcontroller and computer. All parts of the system perform the task in a combined way. The potentiometer converts the electrical input as output voltage, and hence the analog to digital convert the output voltage signal in digital or discrete form so that it can be given as input to microcontroller and hence the data are manipulated based on the program burned in it. In this way we can implement a simple instrument of low cost, which also can perform the work as in plant. This can be easily achieved with simulation software. We can keep our parameters controlled through this system and it will be more beneficial in safety and efficient in manufacturing point of view. So for this project I would develop a DAS (Data Acquisition System) using microcontroller with serial bus communication for collecting and monitoring data on central process computer. Copyright@ International Science Community Association