Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.25 Mechanistic study of chromium (VI) catalyzed oxidation of benzyl alcohol by polymer supported chromic acid Sonawane Vilas Y Department of Chemistry,B.Raghunath College, Parbhani, 431 401 Maharashtra, INDIA Available online at: www.isca.in (Received 17th March 2011, revised 23th March 2011, accepted 30 March 2011) Abstract The oxidation of benzyl alcohol has been studied spectrophotometrically to compare the polymer substrate supported reagent with a commercially available cross-linked polymeric reagent. The reagent supported on anion exchange resin was found to be more efficient in the oxidation reaction. The reagent is very easily separated from the reaction mixture and can be manually removed from the reaction mixture, which remains clear during and after the reaction. The kinetics of oxidation of benzyl alcohol with chromic acid supported on anion exchange resin like Tulsion-T-52 A [Cl] in 1, 4-dioxane has been studied. The reaction is found to be of zero order each in concentration of alcohol and oxidant. The oxidation product have been isolated and characterized by its derivative, UV and FT-IR spectral studies. The effect of substituent’s on the rate of oxidation and the thermodynamic parameters were determined with respect to slow step of mechanism. Keywords –, Mechanistic, Catalyzed Polymer- supported chromic acid, Oxidation, benzyl alcohol, Tulsion-T-52 A [Cl] Introduction Chromium trioxide dissolves in water to form Chromic acid. Chromic acid being one of the most versatile available oxidizing agent. Now a day the development of newer chromium (VI) reagents 1-6for the oxidation of organic substrates continues to be of interest. Chromium is one of the most widely distributed heavy metals in the earth’s crust. It is normally found in two oxidation states i.e. Cr (III) and Cr (V). Chromium is required in small quantities as an essential trace metal. Most of the biological tissues contain Cr (III) which is usually non toxic; where as Cr (VI) is highly toxic to the organism. In the present investigation now herewith report the oxidation of benzyl alcohol by polymer- supported chromic acid. Tulsion-T-52 A [Cl] is strong anion exchange resin supported on chromium (VI) oxide and used as an oxidant. Material and Methods Preparation of supported oxidizing agent: The supported oxidizing agent was prepared by reported method.8-10 The chloride form of Tulsion-T-52 A [a macro reticular anion exchange resin] containing a quaternary ammonium group [10 x 10 kg] was stirred with a saturated solution of  PP N + N + HCrO 4 X aq. CrO Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.2 Chromium trioxide [5 x 10-3 dm] in water [30 x10 dm] for 30 minutes at room temperature using a magnetic stirrer. The chloride ion was readily displaced and HCrO- form of resin was obtained in 30 min. The resin was successively rinsed with water, acetone and THF and finally dried in vaccum at 323 K for 5h. The dried form of the resin was stored and used throughout the kinetic study. Determination of the capacity of chromate form of the polymeric reagent: The capacity of the chromate form of Tulsion-T-52 A [Cl] polymeric reagent was determined by iodometrically. The capacity of the chromate form of resin was 6.90 mmol/g and used for kinetic study throughout work. The loading was also determined by elemental nitrogen analysis and was found to be 6.82 mmol/g. Chemicals and Reagents: All reagents used were of Analytical Grade and all solutions were prepared with double distilled water. Kinetics of oxidation: The reaction mixture for the kinetic run was prepared by mixing benzyl alcohol, oxidant and solvent. The reaction was carried out either constant stirring using magnetic stirrer and at a constant temperature 318 ±1 K. At different time interval, the reaction mixture was withdrawn using a micropipette. The aliquot thus withdrawn was taken in a stoppered test tube containing 5 x 10-3 dm of 1, 4-dioxane and subjected to spectral analysis. The absorbance of the product formed was measured using SL 159 UV-visible spectrophotometer. Duplicate kinetic runs showed that the rate constants were reproducible to within ±3 %. Induced polymerization test: Mixing of oxidant, benzyl alcohol and solvent at 318 K with continuous stirring initiation of reaction. After 30 min, the reaction mixture was withdrawn in a test tube and acrylonitrile was added. The mixture after dilution with distilled water formed a copious precipitate. The precipitate formed, due to polymerization of acrylonitrile, indicates formation of a free radical species in the reaction 11. It was also confirmed by ESR spectral analysis as well as on diluting the reaction mixture with acidified methanol, a precipitate formed, suggested the possibility of free radical interventation in the reaction. Product analysis: The oxidation of benzyl alcohol leads to the formation of benzaldehyde. The product formed was analyzed by their 2, 4-dinitrophenylhydrazine derivatives. The precipitated 2, 4-DNP was filtered off, the product is then vacuum dried, weighed and recrystallised from ethanol. The yield of 2, 4-DNP recrystallisation with the DNP of benzaldehyde was 99%. The product benzaldehyde also identified either by comparison with authentic sample or by UV, FT-IR spectral and elemental analysis. The IR spectra was recorded on a Jasco FT-IR spectrophotometer using KBr pellets. The melting point of 2,4-DNP derivative of benzaldehyde is 509K. UV Spectrum max 247 nm. IR data: - A sharp band at 1690 cm-1 for -CHO stretching mode, 1582 cm-1 aromatic (- C = C-), 3060 cm-1 (-C- H stretch). Result and Discussion Effect of oxidant: The order with respect to weights oxidant is zero, as the plots of absorbance against time were linear in all runs and observed rate constant are fairly constant between 120 to 180 x 10-6 kg of oxidant at constant concentration of solvent (1, 4- dioxane, 10 x 10-3 dm) and benzyl alcohol (15 x 10-3 mol/dm-3), the effect of varying weights of oxidant on zero order rate constant as shown in Table-1. Effect of concentrations of benzyl alcohol: At a varying concentration of benzyl alcohol [10 to 25 x 10-3mol/dm], constant weights of oxidant [140 x 10-6 kg] and constant concentration of solvent [1,4-dioxane, 10 x 10-3dm], zero order rate constant [Table- 2] was found. Effect of dielectric permittivity: It was found that as the dielectric constant of the medium increased, this including r* r [Where r* and r refer to the radii of the reactant species and activated complex respectively] at constant concentration of benzyl alcohol [15 x 10-3 mol/dm] and constant concentration of oxidant [140 x 10- 6 Kg], solvent [10x 10-3dm] as shown in Table-3. 26 Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.3 Effect of temperature: The reaction was carried out at four different temperatures to study the effect of temperatures on the rate of reaction. It was observed that, the rate of reaction increased with an increase in the temperature. [Table-4]. The thermodynamic parameters like energy of activation [Ea], enthalpy of activation [], entropy of activation [] free energy of activation [] and frequency factor [A] were calculated by determining values of k at different temperatures. [Table-5]. Discussion Several sets of experiments with various weights of oxidant, concentration of benzyl alcohol and change in solvent were carried out. The reaction was found to be zero order. The proposed path for the reaction of chromium (IV) then makes possible a different mechanism for oxidation of benzyl alcohol. According to Westheimer and Watanable [12], subsequent steps must involve chromium (IV) as shown in Scheme (II) and (III). Scheme (II) Cr IV + Cr VI2Cr (1) Cr + RCHOH R C = O + CrIII + 2H+ (2) Scheme (III) 2Cr V CrIII + Cr V (3) Cr V +Red Cr III + oxi (4) Westheimer then proposed that the oxidation of primary alcohols proceeded via acid chromate ester intermediates. CHOH + HCrO4 + HCHOCrOH + HO (5) CHOCrOH + H+ CHOCrO+ (6) If the oxidant supported on polymer, which has certain advantages over homogeneous reaction, the intermediate chromium (IV) will further oxidize another molecule of benzyl alcohol to form a free radical species. Thus based on experimental results, obtained for the oxidation of benzyl alcohol by polymer support, the reaction was found to be th order. Initially Cr (VI) is reduced to Cr (IV). It is likely to react with another Cr (VI) to generate Cr (V) which is then reduced in a fast step to the ultimate product Cr (III). Such a sequence of reactions in Cr (VI) oxidation is well known.13-15The mechanism is suggested in Scheme (IV) and involves ester formation. The polymer supported reagent reacts with a molecule of benzyl alcohol to form a chromate ester. Table-1: Effect of oxidant on reaction rate Oxidant x 10 - 6 kg 120 140 160 180 k x 10 - 4 min - 1 2.10 2.15 2.25 2.30 Table-2: Effect of concentrations of benzyl alcohol on the reaction rate Benzyl alcohol 10 x 10 - 3 mol /dm15x 10 - 3 mol /dm20 x 10 - 3 mol /dm25 x 10 - 3 mol /dm k x 10 - 4 min - 1 3.20 4.10 4.50 5.10 Table-3: Effect of dielectric permittivity of the medium on the reaction rate Temperature K 313 318 323 328 k x 10 - 4 min - 1 3.20 4.30 4.90 6.20 2 7 Table - 4. Effect of temperature on the reaction rate Temperature K 313 318 323 328 k x 10 - 4 min - 1 3.20 4.30 4.90 6.20 Table -5. Thermodynamic parameters for the oxidation of benzyl alcohol Energy of activation [Ea] KJ mol - 1 84 ± 4 Enthalpy of activation [ # ] KJ mol - 1 49 ± 3 Entropy of activation [ # ] JK mol - 1 -55 ± 2 Free energy of activation [ # ] KJ mol - 1 256 ± 2 Frequency factor [A] X 10 - 5 s - 1 3 ± 0.5 The ester formed will decompose into aldehyde and the intermediate chromium (IV) will be formed in the second and slow step. N(CHHCrORCHOH (CH)O Cr OH ROH + - + + - + 2 (CH)O Cr OH R P N(CH(Cr)RCHO + - k, Slow IV + + + + 3 28 Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.5 The intermediate chromium (IV) thus reacts with another benzyl alcohol molecule to produce a free radical species. Subsequently the free radical reacts with another oxidant site in the polymeric reagent in a fast step leading to the formation of chromium (V). The intermediate chromium (V) in the last step reacts with benzyl alcohol produce benzaldehyde. Acknowledgements I wish to express my deep sense of gratitude to Hon’ble Adv.Ashok Soni, President, Godavari Shikshan Prasarak Mandal’s, B. Raghunath Arts, Science and Commerce,College Parbhani and Prof. Smt. Nandini P. Hilage, Department of Chemistry, Shivaji University, Kolhapur. Conclusion According to Scheme IV, a second order rate law is expected. But since the first step of ester formation occurs in solid phase and assuming that this equilibrium does not contribute to the rate of reaction. We obtained zero order dependence with rate constant k of the second slow step in which product benzaldehyde was obtained. Based on the experimental observations a probable mechanism is suggested. P N C H 3 3 ( ) r IV C + RCH 2 OH P N C H 3 3 ( ) r C III + RCHOH H + + + + FAST (CHHCrORCHOH FAST N(CH(Cr)RCHO + - + . V + + + + 29 Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.6 References 1. Corey E. J. and Schmidt G., Tetrahedron Lett., 20, 399 (1979)2. Bhattacharjee M. N. Choudhari M. K. Dasgupta H. S., Roy N. and Khating D. T., Synthesis., 58 (1982)3. Corey E. J. Barette E.P.M. and Margrious P.A., Tetrahedron Lett., 24, 5855 (1985)4. Climinale F., Camporeale M., Mello R., Troisi L.and Curci R., Chem. Soc.,Perkon Trans., , 417 (1989) 5. Sharma G. G. and Mahanti M. K. Bull., Soc Chem. Fr., 128, 449 (1991)6. Balasubramanian K. and Pratibha V., Indian J. Chem., Sec. B., 25, 326 (1986)7. Narayana B. and Tam Cherian, J. Braz. Chem. Soc., 16, 197 (2005)8. Jawanjal A. L. and Hilage N. P., Indian J.Chem., 44A, 1827 (2005) 9. Kakde S.A. and Hilage N.P., Trans. Metal Chem., 32, 940-943 (2007)10. Cainelli G., Cardillio G., Orena M. and Sardri S., J. Am. Chem. Soc., 98, 6767 (1976) 11. Brunlet T., Jouitteau C. and Gelhard G., J. Org. Chem.,51 , 4016 (1986)12. Mosher W. A., Clement H. and Hillard R. L., J. Am .Chem. Soci., 29, 565 (1993)13. Watanabe W. and Westheimer F. H., J. Chem. Phys., 61, 17 (1979) 14. Salunke M. M., Salunke D. G., Kanade A. S., Mane R. B. and Wadgaonkar P. P., Synth Commun.,2B, 1143 (1990)15. Matsuo J., Kawana A., Pudhon K., and Mukaiyama T., Chem. Lett., 250(2002) 16. Hutchins R. O., Natale N. R., and Cook W. J., Tetrahedron Lett., 4167 (1977)