Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.63 Role of Photo sensitizer-Reductant for Generation of Electrical Energy in Photo galvanic Cell Chandra Maheshand Meena R.C. *Department of Chemistry,Deshbandhu College,New Dehli-110019, INDIA Department of Chemistry, Jai Narain Vyas University, Jodhpur (Rajasthan)-342005, INDIA Available online at: www.isca.in (Received 29th March 2011, revised 29th March 2011, accepted 5thApril 2011) Abstract We have constructed p-n heterojunction solar sandwich cells with photo sensitizer in a thin film of reluctant placed between a conducting glass coated with indium oxide and a platinum foil. The current-voltage elations of the cells have been measured in the dark and light under both forward and reverse biases. Key words: Power Point, Fill Factor, Conversion Effiency, Rose Bengal, Glucose,TEA Introduction Solar cells convert sunlight directly to electricity with acceptable conversion efficiency. They are virtually free of pollution. There are few reports1-3on the construction of solar cells utilizing the semi conducting properties of dyes. The photovoltaic effect in a sandwich cell consisting of phenol Safranine in the solid polycrystalline state has been reported earlier, the system generates a photo voltage of 90 mV within a few seconds. The dyes have characteristic properties of aggregation, which cause low efficiencies due to self-quenching. To increase the efficiency and overcome to this problem, we have constructed a sandwich cell with a thin film of phenosafranin in polyvinyl alcohol coated onto conducting glass (containing In) and a platinum foil. The preliminary results show that the cell on illumination generates a fairly large photo voltage of 515 mV. This interesting result has led us to make a detailed study of thin-film solar cells consisting of dye such as Rose Bengal and reductants such as TEA and Glucose. The results are reported here. A detailed literature survey reveals that different photo sensitizers and reductants have been used in photo galvanic cell9-33 Material and MethodsThe dyes such as Rose Bengal supplied by Loba Chemicals were twice re-crystallized from ethanol-water solutions. TEA and Glucose (Loba Chemical) were used without further purification. AR grade polyvinyl alcohol (Loba Chemical) was used without further purification. The solutions were prepared with doubly-distilled water. The conducting glass coated with In was supplied by Nesatron (PPG Industries). The thin films (20-30 m thick) of dyes in polyvinyl alcohol were prepared by spreading the solution of dye of known concentration containing a definite amount of polyvinyl alcohol (~0.8 g/10 ml). The experimental sandwich cell was constructed with semitransparent conducting glass containing a thin film of dye in. polyvinyl alcohol and a platinum foil by using spring clips. The construction of the sandwich cell and the experimental set-up were described in an earlier paper31. A tungsten lamp (220V, 300 W) served as light source and had an intensity of 30mW-cm-2. The photo voltage and photocurrent were measured with a Keithley model 642 electrometer and a model 196 multimeter, respectively. Results and Discussion On illuminating the conducting glass of the sandwich cell containing the photo sensitizer dye, a photo voltage develops, which attains a maximum value within a few minutes. This photo voltage decays gradually in the dark. The growth and decay of the cell photo voltages using different Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.64 dyes of different concentrations in the thin film are shown in Fig.1. The open-circuit photo voltage (Voc) increases with increase inµ concentration (C) of dye till it reaches a maximum for effective conversion of light in electrical energy and follows a relation that is similar to the Freundlich adsorption isotherm, i.e. oc= KC1/m, where K is a constant and m is a number greater than one. Power Conversion Effiency of Photo galvanic Cell: One of the important characteristics of any electrochemical cell is its power conversion effiency. The i-V characteristics of Rose Bengal– TEA and Rose Bengal-Glucose. Photo galvanic cells have been investigated to estimate the power conversion efficiency of the cell. The possible power output from the cell can be obtained from the rectangle of maximum area which can be drawn under i-V curve. The power point (appoint on the curve where the product of potential and current was maximum) in i-V curves were determined and their fill factors were also calculated. These data are summarized in table 2. The efficiency of the Rose Bengal-TEA photo galvanic cell has been calculated to be 1.248 percent, comparable to that of and Rose Bengal – Glucose photo galvanic cell has been calculated to be 0.744 percent. Power point (A point where the product of photocurrent and photo potential is maximum is determined by using i-V curve. Where the fill factor and Conversion effiency of the cell is calculated by using following formula. Vpp x ipp Fill-factor (n) = Voc x isc Where Vpp = photo potential at power point. ipp = Current at power point. Voc = potential in open circuit. isc = Current in short circuit. Vpp x ipp Conversion efficiency = x 100% 10.4 Mw / Performance of the photogalvanic cell: All the two systems were studied by applying the desired external load to have the potential and current corresponding to power point. The time t1\2 was determined after removing the source of light. It is the time taken in reaching half the value of power. The performance of cells was studied and comparative values are summarized in table 4. On the basis of the observed data, the Rose Bengal TEA is most efficient from power point of view (Electrochemical Studies of Photosensitizers) The value of K is 3.16 V, The current-voltage relation of the p-n heterojunction cell in the dark is I = I[1-(V/Vbi)] [exp(eV/kT)-1], where Vbi is the total electrostatic potential for the two semiconductorsand k is Boltzmann's constant. When the junction is forward biased, i.e. V (kT/e), then I = I[1-(V/Vbi)] [exp(eV/kT)-1], when it is biased in reverse, i.e. V (kT/e), then I = (V/Vbi)-I where I is the dark current for the system. On the other hand, the photocurrent Idevelops when these systems are illuminated and the current-voltage relation becomes I = I+ I0 [1-(V/Vbi)] [exp (eV/kT)-1], When the illuminated cell is biased forward and in reverse, then I = I+ I0 [1-(V/Vbi)] exp (eV/kT) and I=I+I0 (V/Vbi)-I, respectively. Linear and semilog plots of the current-voltage relations of the systems are shown in Figs. 2 and 3 for the dark and with light when the junctions are biased both forward and in reverse. All of the parameters are calculated from these plots. The ln-coated glass is an n-type semiconductor with a band gap32 of 3.6eV, whereas phenosafranin behaves as a p-type semiconductor. The reported band gap33 for phenosafranin is 2.17 eV. Platinum is used only for ohmic contact. The formation of a p-n heterojunction solar cell is initiated on absorption of visible light by the dye molecules. When visible light is incident on these p-n heterojunctions, an excess of electron-hole pairs is generated and the electrons diffuse to the n-region while the holes diffuse to the p-region. In the absence of an externally applied field, the light-induced current develops a photovoltage across the p-n heterojunction.The conductivities of semiconductor dyes in thin films of reductant increase exponentially with temperature according to the relation(T) = 0 exp (-E/2kT), where E is the band gap for the process and is the Research Journal of Chemical Sciences Vol. 1 (1) April (2011) Res.J.Chem.Sci.65 extrapolated conductivity at infinite temperature. The band gaps of dyes in a thin film of reductant have been determined directly from conductivity measurements and plotting lnas a function of 1/T.The results for Rose Bengal- TEA and Rose Bengal-Glucose are 1302.0, and 1080.0 mV, respectively. There is an interesting correlation between the activation energies of the dyes and the photo voltages generated in the film containing dyes. The lower the band gap of the dye, the greater is the photo voltage generated in the solar cell containing dye. Lower activation energy means that less energy is required to generate charge carriers in the semiconductors. The use of dyes in the film increases the efficiency of photo voltage generation by decreasing self-quenching caused by aggregation. This type of solar cell using a polymer of low resistivity is important since its preparation is simple and the cost is low compared to that of other solar cells. Mechanism: On the basis of these observations, a mechanism is suggested for the generation of photocurrent in the photo galvanic cell as: Illuminated Chamber Dye Dye (6.1) Dye + R Dye (semi or leuco) + R (6.2) Platinum Electrode Dye Dye + e (6.3) Dark Chamber Dye + e Dye (semi or leuco) (6.4) Dye + R Dye + R (6.5) Where Dye, Dye*, Dye , R and R+ are the excited form of dye, semi or leuco dye, reductant and oxidized form of the reductant, respectively. ConclusionPhoto galvanic cells are low cost due to the use of a dye, which are cheap and used in minute quantities reductant like Ascorbic acid, is also not that very expensive. So overall working with a photo galvanic cell has lot of scope for its development. On the basis of observation in the whole study it is concluded that photo galvanic cells are better option for solar energy conversion and storage. Also this system with better electrical output good performance and storage capacity may be used in near future. According to observed photo galvanic effect in all these two systems, Rose Bengal-TEA system was the most efficient in all the ways. Acknowledgements The Authors is grateful to Principal, Desh Bandhu College, kalkaji New Delhi for providing the necessary laboratory facilities References 1. Meier H., Albrecht W. and Tschirwitz U., Angew., Chem. Int. Edn.,11, 1051 (1972)2. Chamberlain G.A., Mol. Cryst. Liq. Cryst., 93, 369 (1983)3. Panayotatos P., Bird G., Sauers R., Piechowski A. and Husain, S., Sol. Cells.,21, 301 (1987) 4. Rohatgi - Mukherjee K.K., Roy M. and Bhowmik ,B.B., Sol. Energy, 31, 417 (1983)5. Bhowmik B.B. and Jana A.K., Energy-The International Journa, 13, 755 (1988)6. Sze S.M., Physics of Semiconductor Devices, nd edn, Wiley Eastern, New Delhi (1983)7. Schumacher L.C., Maniche-Afara S. and Dignam M.J., J. Electrochem. Soc.,133, 716 (1986)8. Meier H., J. Phys. Chem.69, 719 (1965)9. Punjabi P. B., Vardia J., Madhwani S. and Chaudhary S., J. Power Sources,159, 747–751 (2006) 10. Madhwani S., Ameta R., Vardia J., Punjabi P. B. and Sharma V. K., Energy Sources., 29, 721 — 729 (2007) 11. Bohrmann - Linde C. and Tausch M. W., J. Chem. Educ.,80, 1471–1473 (2003)12. Monat J. E. and Mc Cusker J. K., J. Amer. Chem. Soc.,122, 4092 (2000)13. Schwarzburg K. and Willig F., J. Phys. Chem.103B, 5743 (1999)14. Tennakone K. and Kumara GRR.A., J. Photochem. Photobiol.,117A, 137 (1998)15.Yadav Sushil, Yadav R. D. and Singh Gautam, Int. J. Chem. Sci., 6(4), 1960 (2008) 16. Meena R.C., Gautam Singh and K.M., Gangotri K. M., Afinidad 59, 253-256 (2003) 17. Meena, R.C., and R.S. Sindal., Int. J. Chem. Sci., 2(3), 321-330 (2004).18.Ameta, Suresh C., Sadhana Khamesra, Anil K., Chittoro and K.M. Gangotri.,Int. J. Energy Res., 13, 643, (1989).19.Gongotri,K.M., R.C. Meena and Rajni Meena., J. Photochem and photobiol. A: Chem; 123, 93, (1999)20.Gangotri, K.M. and Chhagan Lal., Int. J. Energy Res., 24, 365, (2000).21.Fisher, A.C., L.M. Peter, E.A., Ponomareve, A.B., Walker, and K.G.U. Wijayantha.,J. Phys. Chem. B. 104(5), 949-958 (2000)22.Zhang, Zhi-Ying. and Chun-yanliu., J. Photochem. and Photobio. A: Chemistry 130, 139 (2000)23.Gratzel, Michael., J. Photochem.and Photobiol. A: Chemistry 164, 3-14, (2004).24.Coralie Houarner-Rassin, Errol Blart, Pierrick Buvat and Fabriceodobel., J. Photochem. and Photobiol A: Chemistry 186, 135, (2007) 25. Bandara J., U.W. Pradeep and R.G.S.J. Bandara., Solar cells,170, 273 (2005) 26. Sindal R. S., Gunsaria R. K., Chandra Mahesh and Meena R. C., The Arabian Journal for science and Engineering, 31(2A), 177 (2006) 27. Minna Toivola, Lauripeltokorpi, Janne Halme, Peter Lund, Solar energy materials and solar Cells,91, 1733 (2007) 28. Kenisarin mural. and Khamid Mahkamov, Renewable and Sustainable energy reviews, 11,1913, (2007) 29. Sindal R. S., Chandra Mahesh and Meena R. C., J. Ind. Council Chem., 25(2), 131-136, (2008).30. Sirvi Sonal, Meena Vijay Kumar and Meena R C, J. Indian Chem.Soc. 85, 825 (2008)31. Meena R. C., J. Indian Chem. Soc., 85, 280 (2008)32. Sindal R. S., Chandra M., Kumar V. and Meena R. C., Energy Sources, 31(16), (2009)33. Kumari Manju, Pachwarya Ram Babu and Meena R .C, Energy Sources, 31(11), (2009)